Docsis chat

Hi

Please help me to confirm if in a CMTS C100G I can use
C100G-DS8x96 cards (front) together with C10G-DS-IO08 (rear), that is, a rear card of the C10G model

regards

Hi,

does Arris cable modem support max cpe unlimited? If not, what is the maximum?

Hi

I have few question regarding Docsis and wifi

If wifi access point (non Docsis) is connected to cable modem as CPE, how Docsis looks at MAC addresses of wifi clients?

Does CM store the MAC address of every wifi client?

Does CMTS store client MAC - CM binding for every client?

In addition, does Docsis allow aging out of MAC addresses?

Hi,

I am searching for any links, experiences or materials describing the problem with DHCP rebindings problems of clients. The DHCP broadcast works fine, only unicast DHCP request is not working as it should.

Thank you.

Has anyone had any success bonding 32 SC-QAM + 2 OFDM and achieving 2Gb+ download speeds? I am seeing poor download performance when testing this setup. If we bond just 2 of these channels in any combination, 2Gb+ speeds are achieved. Testing has been done on an Arris TG9452 and Hitron 5x1x modems with various firmware revisions with the same results. This has been tested on 2 different version of Harmonic CMTS (containerized and non-containerized) to Harmonic RPHY nodes in the lab with 2K and 4K modulations at the modems.

Former DOCSIS sales engineer is selling off his home DOCSIS lab equipment. Current listing are posted at:

https://www.ebay.com/sch/i.html?item=115847957883&rt=nc&_trksid=p2047675...

These items are only available for US purchase/shipment.

Most recently this lab environment support DAA RMD and EPON products from Vecima (Gainspeed) and CommScope.

Hi

Does anyone have the latest firmware for the Hitron CGN and CGNVMs, along with MIBS and Provisioning Manuals? Also, does anyone know if the Arris DG3450/TG3452 will shut off it's modem and operate as just a eRouter?

I am looking for Arris Touchstone TM902S firmware TS0710120_072111_EU_MODEL_9_TM902_sto.bin or newest version.
Can anybody post it please? laguna-mc at mail.com

Does anyone remember the commands to do an upstream snr analysis on a cisco CMTS? There used to be a windows utility here somewhere that would show the live SNR at the cmts but for the life of me I can't find it.

The original command I remember was
show controller cable6/0 upstream 0 spectrum 5 55 3

But this doesn't seem to work on the ubr10k revision I have.

TIA!

I have a PRE4 with IOS 122-33.SCH5 and I'm trying to create 16x bonding groups that cross the 24 frequency section of the 72/60 card. From all the advice and examples provided on this site, I believe I have a working config below but I'm not getting bonding on wideband 5/1/0:10 or wideband 5/1/0:11 even when I shutdown the rest of the wideband interfaces. Wideband 5/1/0:9 works fine. I'm not sure if this is IOS version or not since it allows the commands I need. I'm using a Harmonic 6G gateway if that is relevant. Any advice would be great.