We got a BSR64k running in docsis 1.1. We have hooked a modem up directly to the back of it and it is running corrected codewords when streaming data over the internet with an occasional uncorrectable. Is this normal? We are thinking that this should be clean and not running any corrected data. We have tried different modems and slots as well (sb5101, sb5120, and slots 11,12,13). Corrected codewords are about the same no matter what.
I'm trying to do a kind of traffic shaping in Cable Modem, so when traffic reaches the maximum sustained rate of a service flow, the ping reply from cable modem to be stable, not to go from 300 ms to 2000 ms.
Is this related to MaxTrafficBurst maybe?
Below is one of my service flow:.
Upstram Flow
Service Flow Reference = 1
QoS Parameter Set = 7
Traffic Priority = 1
Max Sutained Rate = 512000
I am new to docsis and trying to setup docsis_server to manage a small cable system.
I was wondering if anyone has ever come accross this message and how it can be resolved. This is the message that I am getting in the sys_log from within docsis_server:
NAK -- unknown docsis modem macaddressOfmodem
I reboot the modem and it keeps sending out this message above.
And below is the state of the modem when I run show cable modem on the CMTS. (ip and mac info left out on purpose)
Interface Prim Connect Timing Rec Ip Address Mac Address
Has somebody experience with configuring CM's to trunk different vlan's? A little bit of help in putting me in de right direction would be appreciated a lot. What I liked to try is setting up the following configuration:
2 CM's, both connected to a cisco device, let's say a cat2960 where CM's are connected to ports that are configured in trunk mode. So a trunk is established between both catalysts. CM's are registered on the same CMTS (uBR 10K).
In packetcable project, during the provisioning of the MTA, a configuration file which is in TLV format is downloaded. TLV 43 will contain vendor specific options. What ids the need of this vendor specific options? what type will be the value part of the vendor specific TLV 43?? What will we do with vendor specific information collected from the MTA configuration file ?
Am having a few problems with my new house. We've been supplied with the above modem, and it doesn't seem to be working with my router.
I've got a linksys WRT54G/S router, and have the cable modem plugged into the internet (WAN) port on the router. I then have a wired pc running from the 1st ethernet port and 3 wireless laptops.
I'm getting no connection, and have done what I can in the linksys browser page, have changed it from a gateway to a router, but that didn't change anything. I keep hearing something about double nat
but afaik thats the gateway/router options?
