Does it exist Docsis/Eurodocsis 3.0 modem that is" self-adaptive", have the upload frequency 5-65MHZ, and the download frequency 111-867MHz, so one modem can support both Docsis systems, Docsis and EuroDocsis?
the hardware is ubr10k.
If modem is set as gateway it working fine.
But if its set as Router its failing somehow and i cant seem to find what causing the problem.
The DHCP server is successfully assigning ip to the router and i can see the router part and the modem part in "show ip arp" but i can not ping it.
I cant find whats the problem is it a DHCP problem or UBR10k Config problem
The Router is asking for option 122 without it still dhcp request is successful OPTION: 55 ( 14) Parameter Request List 72 (WWW server)
We are testing a CMTS, this issue occurred.
Could you give me some clue?
1. Make UGS as much as possible below threshold of admission control
2. Added traffic to make drop for all channel
3. Remove main coax cable
4. Cannot make call
5. DSA reject observed in capture
we are having problems getting the MTA of the Fritzbox 6490 and Fritzbox 6340 to work with SIP. The Fritzbox 6360, Cisco EPC3212, Cisco EPC3208 work fine with the same system. The Voice-MTA does not even start a DHCPDISCOVER although the CM-Lease sends the proper DHCP Option 122. Unfortunately we do not have carrier support with AVM for further investigation and the boxes are branded as well. I have some question regarding this:
Ok all,
I just found out several SBG900's on our network are able to still get online after I have sent them a no access configuration. This works on all of our 4100,5100,901,941 motorola units.
What gives? Here is the config I am sending now, limited them to 16k. You can't change maxcpe to 0. What if I put in a mac address reservation of 00:00 etc..
I need a little hint...
I have a problem with EPC3208G and telephony. All of my modems (EPC2202, EPC2203, EPC3208) work fine with voip, but EPC3208G not. Modem is booting, downloading 2nd config mta.cfg and... nothing happens when I lift phone. No phone signal, no LED blinks. Tests (from EMTA_Log.asp) - OK (ring on phone).
Server the same, config the same, everything the same - only "G" is a difference.
I am not getting my modem ip from TFTP sever, not able to telnet CM IP also, modem is connected to correct CMTS,but after downgrading my modem is coming offline, so how I want to bring up my modem by setting the ds frequency. MIB also not working. So how I will do , plz help me.........
Is there someone here using ISC kea as their dhcp, I find that this dhcp supports mysql as backend and I think this is a good dhcp to use for provisioning cable modem but I can;t see any sample configuration that run in docsis cable modem, so if someone already use it can you please share your configuration? or bring us to the right path for creating configuration for docsis CM. Thanks in advance if you can help us.
