I really need a help.
From SNMP by setting the MIB: arrisCmDoc30AccessTelnetPassword (Technician PW) I am unable to active the telnet. Since it is restricted.
So is there any way to active telnet from putty or Xshell by entering the CM IP address?
Plz help me out.
We have a number of PPPoE clients on our uBR7200 series platform. The CMTS is configured as a LAC and a L2TP tunnel is established to a LNS outside our network on a common vLAN. I see the uBR10012 doesn't support this. We have rolled out uBR10012.
Is there any other soution to this?
I need to forward PPPoE packets on vLAN3 if I can't use PPPoE/L2TP config. This is what we do on Arris and Casa CMTS.
I'm having trouble to put my cable modems 2.0 and 3.0 work with BSR64000.
- I see the DHCP Server offering IP (Ubuntu Server + ISC DHCP Server 4.x)
- I see the cable modems on the CMTS.
- I see the IPs offered to cable but they don't lock, don't get the file from tftp server. But the tft server is working fine.
Hi,
I'm trying to upgrade the firmware on some EPC3928D modems. The firmware is installed, but the modem will not come online after the upgrade.
The modem stops at reject(c), and then reboots and starts over with the init process.
The only change I made in the config file is the Software Upgrade Filename line.
After a bit of searching I see that reject(c) could be "bad Class of Service".
can anyone help me configuring docsis_server ( https://github.com/bschirrmeister/docsis_server )?
I install it in ubuntu 14 and there is no error at all but it does't give any IP in the CM.
When I loot at the log files in the DHCP ( /home/docsis/docsis_server.DHCP.3838 )
heres what i got:
*************************
load /2 0 high(16) diff 1444958606
LOG docsis_server DHCP version 3.5 activated
tmp[0]
tmp[3]
tmp[6]
tmp[9]
tmp[12]
tmp[15]
tmp[18]
I'm trying to setup a CMTS (arris C4c) which has IPv6 support, connected devices should query the backend server (an isc-dhcpd server) for an IPv6 address and both the cable modem and any connected devices (i.e CPE devices) should also obtain an IPv6 address (ideally from a different pool).
I have an issue with a Cisco 10k I support. The company is wanting to move to 8 channel bonding from 4 on the MC20x20 line card. Because the company is small the last Mac-Domain is not in use (5/0/4). I removed all interfaces from the domain so that 5/0/0 has 5 upstreams and so on. Similar to Mbowe config he has posted before. The issue I have is this. Modem locks on all 8 channels and 3 upstreams. SNR is 42-45 on all downstreams and 36 on up. Running speed test I get ~280Mbps which is all great!
