Docsis chat

Does anybody have a sample config or user guide for D3.1 config for Arris E6000?
vatiacg.kefo at gmail.com

Hello,

Hi,

I would like to add 8 QAMs into the same downstream bonding group and have an issue.

I could added it to the same service-group:

service group 2
qam 0/1/0
qam 0/1/1
qam 0/1/2
qam 0/1/3
qam 5/2/0
qam 5/2/1
qam 5/2/2
qam 5/2/3
upstream 1/5.0
upstream 1/5.1
upstream 1/6.0
upstream 1/6.1

and also to the same mac-domain.

request was for a modem file for certain customers with 5Mb download speeds to not be allowed to to view streaming services because they stream 24/7 and eat up a ton of data. customers with the 300Mb service aren't limited or capped, but even they only use a small fraction of the overall data of some of the 5Mb service customers.
issue is Hulu uses rtmp and netflix uses dash protocols for streaming, not sure what others like amazon uses.
what's the best way to block streaming on the modem file?

Thank you in advance

Good morning all
I currently have Cisco DPC3825; SW_REV: dpc3825-v302r125574-150723a; MODEL: DPC3825 and there's wifi issues that I hope is resolved with newer firmware.
please let me know if you have newer available to see if it can resolve the wifi issue (low throughput, even within 10 feet. example 3Mb instead of 50Mb)

Thank you in advance
Carlos

Hi,

I am looking for the OID for monitoring the number of all registered cable modems on the CMTS.
I have OIDs for monitoring the numbers of modems on different interfaces...but I would like to monitor the number of modems on the whole CMTS.

Does anybody have the OID for Cisco, CASA?

Thanks in advance, vaitapu

Hi.

My problem is the following:

The Cable Modem only detects 5 frequencies in Dowstream, now when I look at my monitoring system, the graphs show that the balance is being made with 8 Dowstreams.

What can be thinking

I'm looking for whats listed as "a private Arris/Motorola MIB, cmConfigDiplexerControl" that can set the internal switchable diplexer in the modem allowing for 5-85 MHz operation.

Running a Cisco UBR10k MC20x20V cards.

One mac domain works perfect and modems bond to all upstreams and you can see SNR CER and UCER on the interface. A second mac domain doesn't show SNR CER or UCER and does not report any modems on it, but when I look specifically at the interface it does. Is it a docsis 2 thing?

Does the RFGW 10 require any type of data license like the RFGW 1? Are there any major gotchas with a used RFWG 10?

Thanks.