Docsis chat

Hi,
I have one Casa C3000, my current configuration is:

interface qam 0/0
interleave 16
power 520
channel 0 frequency 813000000
no channel 0 shutdown
channel 1 frequency 819000000
no channel 1 shutdown
channel 2 frequency 825000000
no channel 2 shutdown
channel 3 frequency 831000000
no channel 3 shutdown
no shutdown
!

Cant get to the modem using the private IP when on the same circuit. But can get to a arris DG2470

UBR10k PRE4 MC5x20H SIP-600 Wideband SPA
IOS SG6
rfgw-1d
DTI server

8 DS (3 Primary) from SPA and 4 or 2 US with MC5x20H.
We get speeds of more than 100 Mbit/s in DS and only 1 Mbit/s in US on D3 modem (Arris CM820, Technicolor 7200.d).
At the same time, any D2 modem on these US get 2.7 Mbit/s. There is no load on US.
I can't find the reason.

Good day friends.
I have problems creating interface bundle in cmts cisco ubr7246 since it does not show the option to create it, any idea of ​​this error?

I attached show version of my cmts

From time to time IE if we have a power failure or loss of a circuit we have a C4 that when the modems come back online they come back in a DHCPIPPVdone status. We have too reboot the C4 again to resolve this issue. Our cisco 10K never have this problem just the C4.

Any ideas.
My provisioning man says the provisioning tool is not seeing the request from the modems for the IP so they get stuck in this status.

Thanks

C4 only has 3 nodes just launched. SCM processor running from 77 to 100 percent. We have another C4 fully loaded only running at 5 percent.

Any Ideas.

Does anyone have a copy of Arris C4 firmware version newer than version 8.2?

I am looking for a version later than CMTS_V08.02.05.74 preferably version 8.3.

Thanks.
s.seepaul@gmail.com

So I just created a problem for myself the other day. We dropped our analog television service. So I shifted 4 channels from the 500mhz region down into the 200mhz region, saw the modems come back and no problem, less swing staying out of the high end so should be great right?

Is it possible to create wideband groups across cards or will I be maxed out at 20ds for a node?

Part 2... What does the cable rf-channel 0 bandwidth-percent 1 remaining ratio 100 really do?

Does that say I am dedicating 1 percent of the bandwidth to this interface but it can use 100.

So lets say..
integrated cable x/x/x
cable rf-channel 0 bandwidth-percent 1 remaining ratio 100

wideband cable x/x/x
cable rf-channel 0 bandwidth-percent 1 remaining ratio 100

I've heard there is a firmware for the Arris TG1672 that upgrades the puma chip to do 24 or 32 channel bonding. Does anyone have experience or access to this firmware? It would be great to upgrade hardware we already have rather than sell/trash it.
Please send to farewell4950@yahoo.com if you have it.