Docsis chat

Hi there

that Sunday there was a very strange event. out of nowhere the CPU consumption of 3 different CMTS in 3 different cities increased by around 15%. any idea or has anyone been there?

The following cards do not boot on BSR64000
Do you know how to improve it?

・Slot: 5
P/N:506563-034-00

・Slot: 6
P/N:506563-022-00

Hi there

I'm looking for the latest FW for Arris TM602B Docsis 2.0 modem
The one I'm currently using is SW_REV: 6.1.88.EURO

thx
Y

Hello colleagues.
some of you have been lucky with the HITRON cable modem ODI / Mib.
I occupy one to enter remotely through the wan ip.
if they can share them.
slds

Does anyone have experience with the PRE5 ?

Cisco website has hardware installation guides, but there are no configuration guides.

I don't have a uBR10k support contract any more, so couldn't hassle Cisco to provide me any information.

Information that I have discovered so far :

INTERFACE NAMING
=============
Each PRE5 has 4 x SFP+ ports for WAN backhaul

* Te0/0/0 - PRE-A, WAN backhaul 0
* Te0/0/1 - PRE-A, WAN backhaul 1
* Te0/0/2 - PRE-A, WAN backhaul 2
* Te0/0/3 - PRE-A, WAN backhaul 3

We have SB6120 modems on our network which we need to upgrade. Current version on the modems is "SB612X-1.0.3.5-SCM00-NOSH".

Can anyone help me find the latest firmware for these modems?

email: gunes dot tuncay at gmail dot com

I've had mixed results when attempting to perform a command like the following:

cable modem xxxx.xxxx.xxxx dbc downstream bonding-group XXXX

Sometimes it goes without an error, other times I get the following:

% Move failed on CMTS module, errno = S_lbm_DBC_NOT_SUPPORTED_WITHOUT_TCC_ENCODING

Everything is set up the same on this CMTS, so I'm not sure why this happens.

Thanks!

Hi,

I have seen in the past but don't remember what did I change now, because this parameter is empty now.
Does anybody know how to configure that you could see/check the cfg file name and FW version from the CMTS?

show cable modem verbose | include "Configuration file name"
Configuration file name :n/a

show cable modem verbose | include "sysDescr"
sysDescr :n/a

I don't know what parameter must be added into the config file.

Thanks in advance, 0603

Hello.
Does anyone know what the latest firmware is on the CASA C 2200?

I have problem with setting TIME offset - if I set +2, it still not set correct time. I cannot set it manually. Maybe you have any solution for problem with setting time? Maybe new firmware?

Software Version: STDD.01.30
Firmware Name: TC7200.20-DD.01.30-170210-F-5FF.bin

Thanks