Docsis chat

Hello,

Does anyone have access to a CVC for the Cisco DPC/EPC3925 for HW ver 1.0? Please send to farewell4950@yahoo.com

Also, has anyone ever been able to consistently login to the web interface for these modems?

Thanks in advance!

Hello everyone. Im search for firmware for CBN CH7485E Teleculumbus. Now i'm with version: CH7485E-5.510.3.2d-SH. Searching for new one, because this have some bugs.. Can you help me or send?

e-mail: mmetodiev@cable-sw.net

Thanks..

Hi

We are an ISP and we have some SBG6580 cable modem and they do not allow remote access by the Ip Wan.

In the interface web you do not have an option to enable remote access.

Can you tell me a way to enable this remote access option by snmp in the docsis file or if you have a better option

I remain attentive to the answers

Hi

Is anyone running a busy ubr10k / PRE4 / 3G60 (and maybe some SPA24s) ?

What is the max traffic you have seen with this combination ?

With a 10G WAN card in each SIP600, can the PRE4 support full 20Gbps of internet ?

Curious if anyone knows of a Web based Downstream Histogram decoder?
Similar to how you could decode DOCSIS pre-equalization data.
Something similar to this http://www.msarmento.com.br/pre_eq_online.php
Trying to compare and validate my own results from some stuff I've written.

Arris C4 has the following error:
---
Maintenance event: Parity Err-LOCOFOCO: CRC error detected in ring buffer SDRAM-C
---

Redundancy switching of SCM was performed manually.
However, it has not been improved.

Do you know the cause and effective measures?

Thnaks

Hi,

What is the Recommended downstream RF power values pour a 32 channels ?
How do we calculate ? is there a formula to do it ?

Thnaks

pascal

Hello good afternoon colleagues.

Someone here could give me the firmware of the following cable modems:

Hitron gnv2
Motorola sbg6580
 You can send them to the mail misael_eduardo@hotmail.com

and also some method to enter the modem cable hitron from my hub via snmp and thus be able to change the wifi keys or some Oid. Beforehand thank you very much.

misael_software@hotmail.com

We are currently running some of our nodes with 4 upstreams. We typically use 1 3.2mhz and 3 6.4mhz upstreams bonded. I noticed that the CMTS throws a warning for the upstreams that are 6.4 vs 3.2 with regards to the power levels.
If I set all of the upstreams to the same power level, the CMTS will complain with a message like the following:

Config Warning - Config of 5/0 (130 tdB) does not conform to maintaining equal power/hertz with 5/2 (100 tdB). Some performance degradation may occur on 5/0.

Hi,

We have two CMTS, one configured to work for DOCSIS & other for Euro DOCSIS.
Can we club the network in one and migrate all DOCSIS customers to Euro DOCSIS or vice versa ?
What changes required to execute this migration?
Pl help.

Robart