Docsis chat

Hello All,

Does anyone know the MIBs need to query all active modems on Arris C4 and E6K CMTS? A scrape can be done with expect and awk but would seeking a cleaner method using SNMP to roll into a larger script.

Any guidance would be appreciated.

Thanks.

Hi eveybody,

can someone help me getting the MTA Mac Address and CWMP of a Cable Modem via SNMP ?

Thanks
Regards

Philippe

Hi, I´m trying to setting up a CISCO ubr7246vxr.

DHCP & TFTP are in an external pc, ip: 10.0.0.3 wich it´s working OK (in other CMTS -Arris C3-)

But I have a startup config problem. Any advice would be greatly appreciated. This is our recently revised version yet to be loaded:

We sell used Arris Cadant C3 1d/6u - 2 item and used cable modems: TCM410,420 - 300 items, TCW690 - 1 items, DCW615 - 1 items.
If interested this deals, please contact me at: noliktava@mikronet.lv

Dear all,

does anyone got a newer firmware version for the SB5100E? Latest one we got is:

SW_REV: SB5100E-0.3.1.3-SCM01-NOSH; MODEL: SB5100E

In case someone got a newer version, please mail it to: motorola.10.emsi@neverbox.com

thanks
Oliver

Hi!

I'm having a problem upgrading a C4 (actually a C4c, same same). We have a 16DCAM in slot 15 and have a used 32DCAM that is supposed to go in slot 15, replacing the 16DCAM. The problem is that I just can't seem to change the card type (after inserting the 32DCAM in slot 15):

# configure slot 15 type 32DCAM-A
^
Error: You may not change the card type for a previously provisioned card.

Hi, I have bought the modem from Best Buy and brought it to Turkey to use with Turksat's Uydunet Cable service. We have called our Cable service provider and gave them modem's MAC address. They have added it and we were able to get signal. But the modem can not get an IP from the service provider. Also we can not change the Country setting in the modem. Our old modem, which is Netmaster CBW-383Z4, works fine. I have contacted ARRIS but they did not help.

Hi everybody ...

i setup this bsr1000 router to try some modems and amplifier and so on ... now i want to create a service flow for amplifiers and another for modems / voip ... i can change the parameters in config file for up and downstream ... an i can create service flows in cmts and declare it in config file ...

all changes i did to the upstream works perfectly but the changes i made to the downstream doesn´t really take effect ...

Hello,

I tried everything to access the GUI of the TG862 but there`s no way to pass the login and password page.
Here`s a little bit of the configuration file there I`m sending to the CM.

Does anyone knows how to change the login and password? I really did everything.

I am activating the first time a cmts ubr10k and something weird's happening to me. in a test probe at the headend I have a cable modem docsis 3.0 to get 8 downstream channels and 4 upstream channels. when active network the same cable modem takes the 8 downstream channels but only one upstream channel. checked signal, noise, etc. and it's all ok! attached documentation on these tests. someone could explain me what might be happening?

thank you.