Docsis chat

Hi guys,

Vecima and Arris support didn't answer my software requests for a CableVista MCV1100. The image on the system doesn't boot, saying that the CRC is incorrect or corrupt.

We also have a CGM14+ that needs software, but the CableVista software is the most important. If anyone could supply me with a copy of the latest software for these units it would be greatly appreciated.

rkerekesus [at] gmail.com

Thanks.

Hi,

I have a question regarding matching certain types of modems (vendor / macadr ) in a UsPacketClass.
The purpose is to separate traffic into two serviceflows. The default serviceflow will go through one VRF and the traffic I'm trying to match through another VRF.

I can make it work by matching a specific MAC address (see below), but that would mean making A LOT of config files.
Instead I'm looking for a way to match a certain type of vendor or a mask of macaddresses.

I'm kind of stuck at this so any suggestions would be welcome

Hi,

I am using DOCSIS 3.0 CMTS, some modems are showing 2 US ,some only one.
Is there any problem with modems showing only one US? pls suggest

Aero#show cable modem fc4a.e91a.8bdd phy
MAC Address US IF DS IF Sid USPwr(dB) USSNR Timing MicroReflec DSPwr DSSNR Mode
TX RX (dB) Offset (dBc) (dB) (dB)
fc4a.e91a.8bdd 3/0.1/0 0/1/3 150 - 0.7 31.9 - - - - tdma

Hello,

Can someone help me installing docsis_server (http://users.accesscomm.ca/docsis_server/).
Im currently using CentOS 7, but I don't know how this docsis server works in a linux.
By the way Im newbie in linux OS.

Hi,

Does anybody have firmware for epc2203-ESIP-16. I think it is a ver. epc2203-ESIP-16-v202r1262-080530s-CVC060414....Plese sent it on e-mail muharem.d(@)outlook.com

Thaks

Hello,

Im new at working cmts can someone help me to configure our CMTS to work.
We already make the CM to be online and its status is operational but it still doesn't have a internet connection.

Hello all,

I want to deploy internet on an 45 floors tower over coaxcable. The coax cable have been already deployed for tv but not for internet by a german cable provider. This works fine.

They installed the cables with many splitters, it seems that any destination does have at least one of it. Is it possible to have there a working back channel?

Hello Dosis specialists,

does anyone have an idear how to inject my docsis signal at about 700 to 800 Mhz into a tv signal from a cable provider? I think I also must filter out there signal in this range... Any idear?

Regards,
Markus Schraeder

Dear forum,

is it possible to force a D3.0 Modem to use a specific Downstream Bonding Group available on a fiber node? I assume this would be vendor based, we primarily use Cisco EPC3212. Are you aware of any TLV or other config file options for Cisco? I know about generic "Downstream Frequency" setting in confilg file but read about problems with DS bonding in case you use it. Is it probably possible via DHCP vendor option 43?

thanks
Oliver

Hello,

Our Cable Modem and CPE have ip and it has ONLINE status in 'show cable modem' command in C3.
But it doesn't have any internet connection.