Docsis chat

Hi!

Does anyone have a PDF copy of the Arris 9.x "Firmware Guide/Provisioning Manual?" Also how do you setup CWMP option 43.1/125 on a Cisco/Moto/Arris CMTS or router?

Thanks,
Ben

Is there any way I can stop Docsis 2 modems from coming online, either with an OID in a docsis config file, or via something on the CMTS (Cisco UBR 10k). We are in the process of phasing these out from our network and once done, we want to deny access to all modem types less than docsis 3.

Hi

When I check the online cable modems in the CMTS C100G-Casa Systems, I see that some have the # in the information of the DS or US channels, mainly it happens in the US Intf

Hi

Please help me interpret these snmp query results to 2 cable modem to compare and understand

I want to know what is the recommended value of the results of each of these queries to a cable modem

name = "docsIfSigQMicroreflections"
oid = "1.3.6.1.2.1.10.127.1.1.4.1.6"

for example from docsIfSigQMicroreflections what is the recommended value on the cable modem

Has anyone implemented the CASA functionality to move cable modems from one logical port to another based on SNR? some example?
Thank you

Hi

We are an ISP and we have some Arris DG1670A cable modem and they do not allow remote access by the Ip Wan.

In the interface web you do not have an option to enable remote access.

can you help me with the necessary oid to enable remote access with snmp

regards

Hi everyone!

Is that possibble to use the BSR 6400 as a bridge with an external router? We need NAT and as we know the BSR does not support that.

Thx,
imix

Hello everyone , i need the lastest firmware for Pace model D5001, i have the current firmware 2.168.2.37 .
Thanks

Hello.

Can someone give me a general concept if it's possible, or what mechanism can be used to cause eRouter traffic to match the cable bundle instead of sub-bundle?

Thanks

We are starting to implement OFDMA across our cbr-8's. We are running 9.17.06.01z1 image.
issuing the command:
sh controllers upstream-cable 0/0/0 us-channel 12 displays this towards the end of the output:

Mapped to connector 0 and receiver 100
Bind to Cable0/0/0 US2
US phy MER(SNR)_estimate for good packets - 44.0 dB <<<-----------looking for this oid
Spectrum Group is unassigned
Nominal Input Power Level 20 dBmV

I know the power level is wrong, this is our lab... the level is ok for now.