Docsis chat

Hi Group

We have an BSR2K and for a while it was good. About 15 days ago, the cmts turned on the ALM led and blocked. We turned off the device and disconnected from network and replaced for a BSR1K backup. About 3 days ago we turned on and it was good for 40min aprox. but the ALM led tuned on again despite I have access to CLI. The rare thing is that 6 hours later, the ALM led turned off without any reason.

I erase the startup config and from yesterday no ALM at all have been displayed.

So, what could be the reason for this? is possible that the BSR2K failing?

Is there a way to assign CPEs to subinterfaces only through DHCP options?

Hi,

I'm having a heck of a time with a config file. Programmer's block. I'm trying to get 3 packet classifiers. VoIP, port 80 and everything else. I can get VoIP no problem and I can get port PcIpDestPortStart and end to 80 no problem for VoIp. I just can't seem to get a catch all to slow everything else down a bit. Does anyone have any ideas or example files?

Thanks,
Eric

Hey,

Any one know if you gotta have the new DTCC cards or does the old TCC+T1 work with the new MC20x20 linecards?

Martin

hello everybody.

we want to launch voip service for our customers. earlier this year we idenified a white label provider that at first seemed great. prices were good, OSS super easy to use, provisioning was a snap. testing went well and everything seemed great.

Hi,

I am migrating from a terayon to a CMTS running 12.3-23.BC7 IOS, and using docsis server 1.2.0, with Arris modems SW_REV: 5.2.54T.SIP; MODEL: TM602A. Most of the modems get their IPs and CPEs too. However the MTAs are not getting their IP. When I try to configure an instruction "cable helper-address xxx.xx.xx.xx mta", I get the error "Interface Bundle 1, Need to turn on DHCP parse in order to extract embedded device class.".

This situation is rather frustrating since everything is working rather well with the terayon. Have you any sugestions?

TIA,
Rui

Can anybody assit with the procedures for resetting the passwords for the Terayon 3230 3240 CMTS from the console port ?
Thanks

I have Arris 1000 i have configured it but i have one problem modem is connected but after 2 - 3 minutes it disconnects itself.

any idea would be very helpful

regards,
Frost

Hello,

Can someone give me an advice how to recovery my forgotten password on both supervisor level and factory level. At the moment I can not use the command “bootCfg” to configure my C3 cmts in the startup procedure. If I remember correctly I set the same passwords on booth levels but I forgot it.

Thank you for your help!!
Best Regards!

I recently had problem with my CMTS but i will make a request here.

I WANT TO BUY USED MOTOROLA CMTS BSR1000 OR ARRIS 1000 / 1500.

If anyone has any used i would be very happy if somebody can replay to this post.

I'll pay via wire-transfer also i will pay for fast delivery shipment like DHL or FEDEX because it's urgent.

Best regards,
Frost