2019-07-30,14:08:06 RNG-RSP CCAP Commanded Power Exceeds Value Corresponding to the Top of the DRW;CM-MAC=d4:3f:cb:e1:54:35;CMTS-MAC=00:c1:b1:61:98:ed;CM-QOS=1.1;CM-VER=3.1;
2019-07-30,14:08:06 Dynamic Range Window violation
2019-07-30,14:08:06 RNG-RSP CCAP Commanded Power in Excess of 6 dB Below the Value Corresponding to the Top of the DRW;CM-MAC=d4:3f:cb:e1:54:35;CMTS-MAC=00:c1:b1:61:98:ed;CM-QOS=1.1;CM-VER=3.1;
Does anyone know the OID for the Technicolor 4300 series that allows LAN remote access to the webpage GUI after the device has been provisioned? I can access when connected via Ethernet but not over coax interface via HFC address. A MIB library would also be helpful if anyone possesses it.
good day
would anyone happen to have Dpc2300r2-v202r124482-120514as-v6.bin ; Dpc2300r2-v202r124482-111216as-as.bin or higher?
having an issue with the wifi dropping out and reboot needed to restore.
I am looking for TG34xx/DG34xx AR01.01.115 Firmware or newer. It would be really helpful if someone could send me a copy of the latest release as an Arris Support Contract is required if we want access to the Software/Firmware Delivery tool, even though we don't need any additional support.
Is there any solution for different CMTS's to use simultaneously the same public subnet ?
I am currently using CASA CMTS and Motorola BSR 64K.
Constantly i am facing a problem where every time i add a new CMTS or migrate a client from one CMTS to another the client is forced to change it's public ip address and doing so we have to add for each CMTS a different subnet.
Is this a thing that can be done at the dhcp server or CMTS configuration or should i configure a particular file to the modem ?
Hi,
I have configured modulation profile for upstream 16 QAM however modem is picking QPSK for US modulation.
modulation-profile 2
request tdma qpsk off 64 0 16 338 0 16 fixed on
initial tdma qpsk off 640 5 34 338 0 48 fixed on
station tdma qpsk off 384 5 34 338 0 48 fixed on
short tdma 16qam off 168 6 75 338 7 16 shortened on
long tdma 16qam off 192 8 220 338 0 16 shortened on
Does anyone have a valid config for the DEPI control plane on the D5 which works with a Cisco 3G60? I can't seem to get the DEPI control plane on the CMTS and edge QAM to work together.
