Docsis chat

Dear;

             I have an Arris EMTA TM602A and would like to work only as a cable modem. get him to stay online by adding the option 122 in dhcp configuration files speed, but the light is flashing the phone looking mta enabled. how do I disable the mta?

Thank you, Flavio.

For sale Cisco uBr7246VXR; NPE-G1; 2 x PSU AC; 4 x MC28U

I have several bundles in stock, used in good condition,
for details email to: sp5rcu at gmail dot com

Regards
Darek

Greetings,

I need some help trying to find the latest (last) firmware for a few different models of modems. We recently came across a few hundred of each of these and plan to deploy them but would like the most recent (and/or stable) firmware for them.

I'm looking for firmware for these models:

Motorola SB5101
Motorola SB5102
Terayon TJ715x
Arris TM402G (SIP)

Any help would be appreciated.

Regards,
Bill

Upgrading a Arris C4 to DOCSIS 3.0? We can supply for under $12,000 (Adding a RCM and 16D card)

Greetings!

We currently have some surplus Arris C4s that we are parting out-

Does anyone know if the motorola bsr 1000 support vrfs? Basically I want to setup a vrf for out of band management and use the default routing table for the cm service.

Also do they support vlans?

Thanks.

I've got SCM8014w-g modems with 4.05.29 firmware, wanted to know if there was anything newer, have an issue where they lockup. believe it to be some type of buffer issue.

Thanks in advance

Carl

Completely stranger to DOCSIS enviroment, I have question about IP addressing and perhaps how DHCP is setup in this network.

Hello

I am try to install a provisioning, and I get a CNR 6.0 licence, but I dont know the method to know the capacity of this license.

any body know how I can know it? or maybe can help me to get a licence to 7.0 or 8.0?

Thanks

I'm new in this Forum. My Problem is bringing up the MTA of a EPC2203.
The MTA makes his DISCOVER-Req and gets a OFFER. This is then repeatet endles.
The Spec says CM Opt 122.1=255.255.25.255 disables the IP-Check (all DHCP-Answers will be usable)

is there a command can put into config file to make docsis 3.0 modem into factory mode?
I am working on motorola cisco and arris modems.

I can not find any info around for docsis 3.0