Docsis chat

Hi guys!

I have little problems.
We installed 3 arric c3 few days ago and i got that problem if is put the cmts US to ATDMA and modulation profile 27 (qam32) then the modems suck at init(rc) and not getting dhcp. If i put it back to modulation profile 21 (qpsk) works perfect.

what can i do?

I have some TX32 cards that are showing muted after upgrading them from 8546 to 8629. On the Chassis I am currently running boot ROM of 7.0.0.43 with a firmware of 7.0.0.5 on my SRM4.

Any clue why this would happen? The front of the TX32 cards are all greened up and look happy. See below output showing that the cards are muted. Any help to figure this out would be great.

Thanks

Hi all,

I'm trying to duplicate the bandwitdh with my ubr10k using LACP, the problem is that when i configure the CMTS and the switch the traffic, alternate between two ports of the switch, cutting the service for a few seconds.

This is my config on ubr10k and switch:

UBR10K:

interface Port-channel1
ip address 192.168.123.13 255.255.255.0
no negotiation auto

Hello everyone!
today, i need setup ssh on my Bsr 64000, pls tell me how to configuration it
Thank a lot!

Let me preface, this is all new to me, so take it easy on me, and thank you in advance !

Dear all,

Does anyone have an STB configuration file where I can access the serial number, CA ID and other informations concern stb?

I'm trying with a generic cable modem template, but I get just the basic information about cable modem embedded.

Thanks,

Rafael

Hi,

have you any idea how to configure the Cable modem to support Energy Managment Mode 1x1 connected to Arris C4 CMTS?

In Arris C4 this feature is enabled : configure cable modem energy-mgmt battery-mode1x1

Thanks,
Issam

Hi ,
Is there a way to set eRouter OIDs without invoking TLV202 on the configuration file ?

Any advice or assistance would be greatly appreciated.
Thanks.

Dear,

              I have a cmts ubr10k with pre-2 card and 5 20x20 card. The 7/1 slot card is constantly on / off. I was able to get the log when this error occurs. See attached data, has anyone ever had this problem? Is it hardware?

Flavio.

Hello,