Docsis chat

Does anyone know the SNMP OID to access these numbers from a Cisco CMTS

Dear, I have the following error on a SPA-5X1GE-V2 card in a cmts cisco ubr10k. I'm using the ios ubr10k4-k8p6u2-mz.122-33.SCH3. can solve this or is it a hardware problem?

Hi all,

The host authorization on command on BSR is used to enforce the binding of the CM and CPE
MAC addresses to the IP address assigned to them.

Which command is the equivalent for it on Cisco Ubr?

Thanks in advance.

Good morning

I have a problem, I tell you that my cable modems do not exceed 2Mb of upload, in the tests I do only show up to 20 Mb of download but upload only 512Kb and for more than try it does not rise even a Mb, then I will detail the configuration file of my cable modem to see if any opinion or someone who has gone through the same problem gives me their support.

I will attach the Image of my Config File that I am using for my aproving.

Config CMTS C3 ARRIS

Hi All,

My log file on bsr64000 is full with entries like bellow:

Hi,

I am monitoring some cable modems using the snmp querys as follow

snmpwalk -v 2c -c public 10.58.0.41 DOCS-IF-MIB::docsIfSigQUnerroreds.3
snmpwalk -v 2c -c public 10.58.0.41 DOCS-IF-MIB::docsIfSigQUncorrectables.3
snmpwalk -v 2c -c public 10.58.0.41 DOCS-IF-MIB::docsIfSigQCorrecteds.3
snmpwalk -v 2c -c public 10.58.0.41 DOCS-IF-MIB::docsIfCmStatusResets.2

I would like to know if there is any snmp query to reset or clear this counters, instead to reboot the cable modem.

thanx!

Asaf Kolman

Hi,
If someone has experience with kind of cable modem, I need to enable remote access WAN for this cable modem.
If someone can give the mib-s will help a lot, so can apply the OID to the .cfg file.

Thank you.

I am receiving a ton of these

Hi guys,

I know RGB promised a future update would bring M-CMTS functionality to the USM100 edge QAM, but I can't actually find any mention of the feature actually being implemented. We have an older software version, 2.0.x and were hoping someone with a newer release would know when it was implemented

Also, in the sysconf I can see a variable referencing the DTI port, but there's obviously no DSchannel-ID config variable per qam in this version.
sysGlobalDTIClockEnable.0 = INTEGER: disable(0)

Thanks

So I have done a lot of changes, reducing upstream power, monitoring frequencies etc but I still have an issue, is it a modem type? I have finally gotten all modems/upstreams to docsis 2.0, but I have modems that come online, bond, then reboot, on the same node I have rock solid modems. Here is one modem I cannot get to stay online, it locks and then reboots.. This is our cleanest plant in apartments and yet.. it won't stay on... so wtf?

CM Initialization Reason : NO_PRIM_SF_USCHAN