OID NAT Bridge Mode Arris CM | docsis.org

You are here

OID NAT Bridge Mode Arris CM

3 posts / 0 new
Last post
Oliver Behrens
OID NAT Bridge Mode Arris CM

Hello togheter!

I am looking for the OID for putting the NAT in a Arris CM TG2492 to Bridge mode. I can not find it in the OID table of the modem.... Can someone help me?

Thank you very much!

Olli

mbowe
Probably this one

Probably this one

arrisRouterWanIPProvMode OBJECT-TYPE
SYNTAX INTEGER { disabledBridge(0), ipv4(1), ipv6(2), dualStack(3)}
MAX-ACCESS read-write
STATUS current
DESCRIPTION "It controls the eRouter mode. When set the value to 'disabledBridge(0)', it will put the device into
full bridge mode(all the subnets become bridge mode) and turn off the WiFi radio. When set the value to ipv4(1)/ ipv6(2)/ dualStack(3),
it will put the device into corresponding router mode and turn on the WiFi radio."
::= { arrisRouterWanConfig 17 }

Oliver Behrens
It`s not working... i try

It`s not working... i try

SNMP MIB Object(unknown OID 1.3.6.1.4.1.4115.1.20.1.1.1.17.0):1.3.6.1.4.1.4115.1.20.1.1.1.17.0, Integer, 0

But the router mode is still on.