Bigband cuda 12000 | docsis.org

You are here

Bigband cuda 12000

3 posts / 0 new
Last post
netcrash
Bigband cuda 12000

Hello,

I'm having trouble setting the interface upstream description, it seems like I only can set the cable description and not for each upstream. I haven't seen any info on this on the manual.

Any tips ?

Best regards,
FR

sajjiboy5
Configuring Upstream

Following lines might help u:

cli:CMTS:root# interface 3/1
mode: interface:cable:csi(1/3/1)
cli:CMTS:interface:cable:csi(1/3/1)# upstream 1 no shutdown
cli:CMTS:interface:cable:csi(1/3/1)# upstream 1 data-backoff 3 10
cli:CMTS:interface:cable:csi(1/3/1)# upstream 1 range-backoff 1 2 frequency ( 5.0 ... 42.0 ) MHz
cli:CMTS:interface:cable:csi(1/3/1)# upstream 1 frequency 35
cli:CMTS:interface:cable:csi(1/3/1)# upstream 1 power-level 250
cli:CMTS:interface:cable:csi(1/3/1)# upstream 1 channel-width 200
cli:CMTS:interface:cable:csi(1/3/1)# upstream 1 modulation-profile 2

netcrash
All that is ok , no problem

All that is ok , no problem there.

My problem is setting a upstream interface description.

Cisco example:
(config)# int cable 5/0
(config-if)# cable upstream 0 description NODE01
(config-if)# exit

But I can't find how to this in Bigband cuda 12000 only can do it in the downstream:
(config):Cuda:cable:csi(1/3/2)# description DownstreamNodeAll

cli:Cuda:root# sh version
BigBand Cuda 12000, Software Version 6.0.1 (21)
Built 2006_06_20_121451 from Release6.0_Integration

any tips ?

Log in or register to post comments