BSR64000 Config Example | docsis.org

You are here

BSR64000 Config Example

3 posts / 0 new
Last post
rlejeune
BSR64000 Config Example

Needing a example of config file for a BSR64000 runnning docsis 3.0. I can't seem to get mine working.

cmcaldas
need more info

post a show chassis stat so we know the cards used and software running, as well as your email.
it would depend on the cards in use and bonding limits.

rlejeune
MOT:7A#show chassis status

MOT:7A#show chassis status

Current Time: 10/26-03:50:23
Running archive: FLASH:6422.srm4.z

Slot Type Sub Red State RM IO UpTime LastUpTime Success Failure
0 DRX RX48 - RUN x x 14:31:35 1 1
1 - - - - 0 0
2 - - - - 0 0
3 - - - - 0 0
4 - - - - 0 0
5 - - - - 0 0
6 - - - x 0 0
7 SRM4 8 RUN x x 14:34:53 0 0
8 SRM4 - stby x - 14:29:47 1 1
9 - - - x 0 0
10 - - - - 0 0
11 DTX TX32 - RUN x p 00:26:05 14:02:58 2 2
12 - - - x 0 0
13 DTX TX32 - RUN x p 00:25:59 14:03:03 2 2
14 HSIM GE2/ETH8 - RUN x x 14:32:05 1 1
15 HSIM GE2/ETH8 - RUN x x 14:32:06 1 1

MOT:7A#
------------------------------------------------------------------------------------
I think my current config is correct but i'm not getting any RF out. I have only used Cisco gear in the past. Thought i would give the bsr64000 a shot this time but its driving me crazy. Per manual it says i need to assign a cable bundle 1 master to interface cable 0/0 but when i do that it give me a error. "master assignnment failed, Dtx not supported".

email: lejeunerj@hotmail.com

Log in or register to post comments